Table of Contents
Advertisement
5.7
SCO UnixWare Server
5.7.1 LSI
A. Building the SCO UnixWare C8XX BTLD Diskette
To create a C8XX BTLD diskette to use with UnixWare 2.1.X or UnixWare
7, copy the raw dd image file onto a 1.44MB floppy disk. This process is
dependent upon the operating system that you are using to create this
diskette. See the instructions below for UNIX System and DOS System
Users. After you have created the driver disk, label it "
UnixWare driver
For UNIX System Users:
Follow these steps to create the BTLD diskette:
1. Insert a 3.5" diskette into the floppy disk drive.
2. At the UNIX prompt, type:
dd if=/<path>/unixware.dd of=/dev/rfd0
The <path> is where the dd image is located. For UnixWare 2.1.X,
the dd image file is located here:
\Drivers\Sdms\Drivers\UNIXES\UNIXWARE\UW21X\UNIXWARE.DD
For UnixWare 7, the dd image file is located here:
\Drivers\Sdms\Drivers\UNIXES\UNIXWARE\UW7 \UNIXWARE.DD
5-34
®
SCSI Driver Installation
".
PCI SCSI SCO
Chapter 5: OS Installation
Advertisement
Table of Contents
