IBM 436854u - System x3200 M2 5U Mini Tower Server User Manual page 56

v When you start the server for the first time after you install a Remote Supervisor
v The server scans PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, and
v For a list of supported optional devices for the server, see http://www.ibm.com/
Attention:
the server is powered-on might cause the server to stop, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
See "System-board optional-device connectors" on page 18 for the locations of the
expansion slots and the Remote Supervisor Adapter II SlimLine connector.
To install an adapter, complete the following steps:
42
System x3200 M2 Types 4367 and 4368: User's Guide
Adapter II SlimLine, the startup process will take several minutes longer than a
typical startup.
PCI slots 4 and 5 to assign system resources. Then, the server starts the PCI
devices in the following order, if you have not changed the default startup
sequence: PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, PCI slot 4,
and PCI slot 5.
servers/eserver/serverproven/compat/us/.
Static electricity that is released to internal server components when
1. Read the safety information that begins on page v and "Installation guidelines"
on page 20.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the side cover. See "Removing the side cover"
on page 24.
3. Follow the cabling instructions, if any, that come with the adapter. Route the
adapter cables before you install the adapter.
4. Follow the instructions that come with the adapter to set jumpers or switches, if
any.
5. Rotate the rear adapter-retention bracket to the open position and remove it
from the server.