Table 7. Illustrations of the server models with four and eight drive bays
Server model with four hot-swap drive
bays
Drive-tray
assembly
Drive tray handle
(in open position)
c. Gently slide the drive assembly into the drive bay until the drive stops.
d. Rotate the drive tray handle to the closed (locked) position.
e. Check the hard disk drive status indicator to make sure that the hard disk
drive is operating correctly. (You might have to restart the server before the
drive is recognized.) If the amber hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must be replaced. If the
green hard disk drive activity LED is flashing, it indicates that the drive is
being accessed.
Note: If the server is configured for RAID operation using an optional
ServeRAID adapter, you might have to reconfigure your disk arrays after you
install hard disk drives. See the ServeRAID documentation on the IBM
ServeRAID Support CD for additional information about RAID operation and
complete instructions for using ServeRAID Manager.
6. If you are installing additional hot-swap hard disk drives, do so now.
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 52.
Server model with eight hot-swap drive
bays
Drive-tray
assembly
Drive tray handle
(in open position)
Bezel
Chapter 2. Installing optional devices
37