Desa (V)DVF36 Owner's Operation And Installation Manual page 29

OPERATING FIREPLACE
Continued
D. Do not use this appliance if any part has
been under water. immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
LIGHTING
INSTRUCTIONS
1. SToP! read the safety information begin-
ning on page 28 before proceeding.
2. Set the "hi-Lo" knob to the lowest setting.
3. Turn off all electrical power to the appliance.
4. open control access panel.
5. Push in gas control knob slightly and turn
clockwise
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
if you smell gas, SToP! Follow "B" in the
safety information, page 28. if you don't
smell gas, go to the next step.
7. The pilot is located by the main burner.
8. Turn knob on gas control counterclockwise
to "PiLoT".
9. Push in the control knob all the way and
hold in. immediately light the pilot by
pressing the ignitor button until a flame
appears one (1) minute after the pilot is lit.
release knob and it will pop back up. Pilot
should remain lit. if it goes out, repeat steps
5 through 9.
• if knob does not pop out when released,
stop and call gas supplier.
• if the pilot will not stay lit after several tries,
turn gas control knob to "oFF" and call
your service technician or gas supplier.
10. Turn gas control knob counterclockwise
to "oN". Knob can be turned to "oN"
only if the control knob is popped out.
11. Set "hi-Lo" knob to desired setting.
12. Turn on all electric power to the appliance.
Gas Control
Knob
E
Position
Indicator
Figure 59 - Millivolt Control Valve
56131-F
to "oFF".
16AI
A
Flame Adjustment
Knob
www.desatech.com
Thermocouple
Figure 60 - Pilot
TO TURN OFF GAS
TO APPLIANCE
1. Turn off the wall switch.
2. Turn off all electric power to the appliance
if service is to be performed.
3. remove control access panel.
4. Push in gas control knob slightly and turn
clockwise
5. replace control access panel.
ELECTRONIC
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BeFore LiGhTiNG smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WhAT To Do iF YoU SMeLL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• if you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. if the
knob will not push in or turn by hand, don't
try to repair it, call a qualified service tech-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
Piezo Ignitor
Pilot Burner
Thermopile
to "oFF". Do not force.
9