Configuring The Network Settings <Network - Sanyo VDC-DP9584N - Network Camera Instruction Manual

Configuring the Network Settings <NETWORK>
Configure the settings required for connecting the camera to the network (LAN) in the menu screen.
• After you turn on the power, it takes approximately one minute for the "NETWORK" setting menu to appear on the
"OPTION" screen. When connected to the network, the link lamp on the circuit board lights as illustrated in the figure
shown right.
1
Select <OPTION> and press the SET button.
CAMERA
PRESET POSITION
AUTO MODE
AUTO RETURN
ALARM
PASSWORD
LANGUAGE
·OPTION
·OPTION
PRESET
MENU
2
Select <NETWORK> and press the SET button.
OPTION
TITLE
PRIVACY MASK
·NETWORK
·NETWORK
SET y
1 y
SEQ y
SET
OFF
SET y
R
SET y
SET y
SET y
OFF
END
SET
R
OFF
SET y
SET y
Configuring Options <OPTION>
3
IP address setting
1 Select <IP ADDRESS>, specify the option for
retrieving the IP address, and press the SET
button.
·IP ADDRESS
PORT
ALARM OUT
·IP ADDRESS
MAC ADDRESS
FIX : Manual configuration (Default IP address: 192.168.0.2)
AUTO : Automatic configuration (DHCP)
Check the configuration and advance to step 4.
• The "MAC ADDRESS" cannot be changed.
Link
lamp
NETWORK SETTING
SET
FIX y
00080
R
ON
08-00-7B-81-12-20
46