Troubleshooting Guide - Uniden UBW2101 Owner's Manual

Troubleshooting Guide

If you have any trouble with your baby monitor, check this section first. If you
need help, visit the customer support page of our website listed on the front
cover.
Problems Possible Causes
No power supply to
camera (Battery low)
Camera is not paired
System
with receiver
message
shows
Service out of range
"NO Signal"
Signal being blocked
Antenna directional
limitation
Signal being blocked
Low signal
or unstable
Strong radio
signal
signal nearby
Strong
electromagnetic
interference nearby
Recording
No SD card
does not
SD card locked
work
Black screen
& buttons are
Power save mode on
not
functioning
Audio Camera and receiver
feedback are too close
VOX Record
VOX Menu set to
& Alarm do
"OFF"
not work
Remedies
Check power adapter and power
cable connection, or battery has run
out.
See pairing operation for detail.
Move the camera closer to the
monitor.
If possible, remove major obstacles
in between the camera and monitor,
or relocate the camera to a different
location.
Adjust camera and monitor position.
If possible, remove major obstacles
in between the camera and monitor,
or relocate the camera to a different
location.
Keep WiFi router away from the
camera and/or monitor.
Keep working motors (hair dryer/
electric heater/air conditioner/water
pump) or microwave oven away from
the camera and/or monitor.
Insert SD card into SD card slot.
Unlock the SD card.
Press the power key to resume
receiving the image. Please refer to
Power Saving section on page 12 for
details.
The camera has a high sensitivity
microphone. Keep the camera at least
10 feet away from the receiver. If the
camera must be within 10 feet of the
receiver, keep the volume down.
Set VOX Sensitivity/VOX Alarm/VOX
Record to ON.
16