Table of Contents
Advertisement
MANUAL SETUP
To achieve the best quality surround sound, you can use MANUAL SETUP to fine-tune the listening environment
parameters, as well as to make advanced settings for sound signals, sound beams, digital input and the OSD. Change the
initial settings (indicated in bold under each parameter) to reflect the needs of your own listening environment.
y
• You can save the settings optimized by the AUTO SETUP procedure (see page 36). A set of settings optimized according to specific
conditions of your listening environment can be recalled later depending on the varying conditions of your listening environment (see
page 37).
• Most of the parameters in SOUND MENU and BEAM MENU are automatically set when you run AUTO SETUP (see page 29). Use
SOUND MENU and BEAM MENU to make additional adjustments.
• BEAM MENU allows you to make settings for the surround sound effects normally available in the speaker settings menu.
• Make settings for the parameters in BEAM MENU first before you make settings for the parameters in SOUND MENU, INPUT
MENU and DISPLAY MENU.
SOUND MENU
Use to manually adjust various parameters related to the sound output.
Item
TONE CONTROL
SUBWOOFER SET
MUTE LEVEL
AUDIO DELAY
ROOM EQ
DD/DTS Dynamic Range
BEAM MENU
Use to manually adjust various parameters related to the sound beam output.
Item
SETTING PARAMETERS
BEAM ADJUSTMENT
IMAGE LOCATION
INPUT MENU
Use to manually adjust various parameters related to the audio and video input.
Item
INPUT ASSIGNMENT
INPUT MODE
INPUT TRIM
INPUT RENAME
DISPLAY MENU
Use to manually adjust various parameters related to the display.
Item
DIMMER SET
OSD SET
UNIT SET
60
En
MANUAL SETUP
Adjusts the output level of high-frequency or low-frequency sound.
Adjusts the various subwoofer settings.
Adjusts the muting level.
Adjusts audio delay.
Adjusts the tonal quality of the listening room.
Adjusts the dynamic range of Dolby Digital or DTS signals.
Adjusts listening room and listening position settings.
Adjusts various beam settings.
Adjusts the sound position of the front left and right channels.
Assigns jacks according to the component to be used.
Selects the initial input of the source.
Adjusts the input level of the source.
Renames the displayed input source.
Adjusts the brightness of the display.
Adjusts the display position and the background color of the OSD.
Changes the display unit of measurement.
Features
Features
Features
Features
Page
66
67
67
67
67
68
Page
62
63
66
Page
68
69
69
70
Page
70
71
71
Advertisement
Table of Contents
