Playing Back Sound Clearly (My Beam); Using Auto-Adjust Function - Yamaha YSP1100SL Owner's Manual

PLAYING BACK SOUND CLEARLY (MY BEAM)

PLAYING BACK SOUND CLEARLY (My beam)
You can improve listenability in a noisy environment by changing the beam mode to the my beam, outputs sound beams
directly to the listening position in a single channel. In addition, the my beam is also ideal if you do not want the sound
beams to be reflected on the walls in your listening room or if you do not disturb others asleep while enjoying music or
movies at night.
STANDBY/ON
5BEAM
1
STEREO
4
MUSIC
7
OFF
0
CH LEVEL
TEST
Note
If the my beam is selected as the beam mode, the surround modes (see page 44), the CINEMA DSP programs (see page 50) and the
TruBass (see page 57) become ineffective. In addition, no audio is output from the subwoofer connected to this unit.

Using auto-adjust function

The my beam microphone on the remote control collects
the test tones from this unit, and then the beam angle is
automatically adjusted.
1
Set the operation mode selector to YSP to
switch to the operation mode of this unit.
TV/AV
2
Press and hold MY BEAM on the remote
control more than 2 seconds.
A test tone is output twice from this unit. Keep
pointing the remote control toward this unit during
the test tones are being output so that the my beam
microphone can collect the test tones.
Control range: L50° to R50°
Operation guarantee range: 6 m, L30° to R30°
MY BEAM
48
En
My beam
microphone
POWER
POWER
AV TV
ST+3BEAM 3BEAM
2 3
MY BEAM SURROUND
5 6
MOVIE SPORTS
8 9
+10
MENU
TV/AV
ENTER
YSP
RETURN
YSP
5
Notes
• If an error occurs, an error buzzer is played and MY BEAM
ERROR is displayed on the front panel display.
• An error may occur if the listening room is noisy. Make sure
that the listening room is as quiet as possible during the test
tones are being output.
• Do not shake or move the remote control during the test tones
are being output.
• Do not cover the my beam microphone on the remote control
during the test tones are being output.
• The batteries in the remote control may be week if the remote
control does not function properly. In such case, replace all the
batteries and then try the procedure again.