JVC VN-C215V4U - Fixed Ip Network Mini Dome Instructions Manual page 21

1
Towards the shooting
direction
Fall-prevention
wire
(not supplied)
4.
Connect the LAN cable. (A Pg. 26)
5.
Connect the power cable and the alarm
cable. (A Pg. 24)
Memo ：
● The power cable must not be connected
when PoE is used.
6.
Wind the waterproof tape. (A Pg. 26)
4
Outer case
mounting screw
Less than 3 mm
Towards
fastening
hook
From the
ceiling slab
3
T Loosen
sufficiently
5
Solder or crimp
Insulation tape
Wind the waterproof
6
tape.
Mounting
1.
Align the secured outer case with the
position alignment mark of the camera.
Note ：
● Make sure that the cables are not caught in
the outer case.
2.
2 Turn the camera in the clockwise
direction.
T Check that the ○ mark can be seen. (Refer
to the diagram below)
3.
Tighten the Camera Fastening Screws
and secure the camera.
Position
alignment
mark
1
Image adjustment
When the camera is mounted, adjust the image
settings while looking at the actual image.
(A Pg.27 Image adjustment )
Mounting the Dome Cover
After the image adjustment is completed, mount
the dome cover.
Installation is complete when the dome cover is
mounted.
(A Pg.29 Mounting the Dome Cover )
2
T Check
Camera
Fastening
Screw
3
21