Honeywell HCCM474M User Manual page 33

LENS INSTALLATION AND ADJUSTMENT, CONTINUED
DC type lens ; Set lens switch to DC.
Connect the lens cable of a DC (galvanometric) type lens. If the plug on the cable is of a
different type, replace it with the provided 4-pin iris plug.
Damping coil (-)
Damping coil (+)
Pin Assignment : DC type (4-pin)
1
2
After installing the connector plug, connect it to the lens connector on the rear
panel of camera.
REV. B
1
2
3
Pin No.
1
2
3
4
4
Drive coil (+)
3
4
Drive coil (-)
Signal
Damping coil (-)
Damping coil (+)
Drive coil (+)
Drive coil (-)
33 HCMU000878
12/29/03