Desa CDCFTN Owner's Operation And Installation Manual page 13

INSTALLATION
Continued
For Built-In Installation
WARNING: A licensed electrician must connect the
wiring harness to electrical supply following all local
codes. Electrician must provide a clamp on the box cover
to secure the wiring. Wiring should be routed through the
bushing in the hole on the outer casing of fireplace.
1. Install snap bushing from blower kit into one hole on rear of re-
mote/blower bracket (see Figure 17). The other hole is for a strain
relief clamp (not supplied) to secure incoming electrical supply.
2. Follow steps 2 through 6 in Installing Blower Accessory, page 12.
3. A licensed electrician must follow the wiring diagram to connect
incoming electrical supply to fan kit wiring harness (see Figure 18).
4. Plug power cord to outlet receptacle (not provided) as shown in
Figure 17. Wind extra cable of power cord and tie up with plas-
tic wire strap (see Figure 17). Set cable bundle between the re-
mote/blower bracket and outer casing, away from the burner.
5. Test to make sure blower is working properly.
6. Reinstall upper louver beginning with bottom screws (see Fig-
ure 11, page 10) and close lower louver.
Blower Bracket
Assembly
Screw
Switch
Power Cord
Switch
Plate
3
2
1
Blue
Red
Black
Plastic Wire
Strap
Figure 17 - Installing Blower Bracket Assembly
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111244-01A
Wire Harness
Outlet Receptacle
(not included)
Wire
Harness
Lower Louver Door
Installing Blower Accessory GA3450TA (Cont.)
110/115
V.A.C.
Black
White
Green
Figure 18 - Wiring Diagram For Blower Accessory Built-In
Installation
Extension Cord
Use extension cord if needed. The cord must have a three-prong,
grounding plug and a three-hole receptacle. Make sure cord is in good
shape. It must be heavy enough to carry the current needed. An
undersized cord will cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16 AWG cord for lengths
less than 50 feet.
Clamp Connector
(not included)
Remote/ Blower
Bracket
INSTALLATION
Fan Switch
(Auto/Off/On)
Auto
1
2
Off
3
Blue Thermostat
Switch
On
(N.O.)
Blue
Red
Blower
Motor
Red
White
Green
13
13