Vanguard SBVBN(A) Owner's Operation And Installation Manual page 6

B-VENT FREESTANDING FIREPLACE
FREESTANDING
FIREPLACE
ASSEMBLY
Continued
Door Catch Bolt
With Adjustable
Door Hinge Step
Hex Nuts Hole
Bolt Hole
Leg
Front
Hole
Stove
Bottom
Hole
Leg Hole
Bottom Of
Stove Unit
Figure 9 - Locating Threaded Holes for
Stove Bottom, Legs, and Door Attachment
Washers
Bolt
Leg
Figure 10 - Attaching Stove Legs
Washers
Bolt
Stove Bottom
Figure 11 - Attaching Stove Bottom
®
10. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Fig-
ures 9 and 12). Use an adjustable
wrench or a 12mm socket to fasten step
bolt. Tighten step bolt until snug. Make
sure door moves freely.
11. Install door catch bolt (M8 x 1.25-
55mm with two M8 hex nuts) into
Leg
threaded hole on stove body (see Fig-
Hole
ure 9). Use an adjustable wrench or a
12mm socket. The catch bolt has two
hex nuts attached to it (see Figure 13).
The top nut is a bolt stop and the bot-
tom nut is for door leveling adjustment.
12. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position.
13. Carefully lift stove back up on its four
attached legs.
14. Set top grate into stove top.
Stove
Door
Door
Hinge
Bottom Of
Stove Unit
Step
Bolt
Bolt
Shoulder
Figure 12 - Attaching Stove Door
Bottom Of
Stove Unit
Figure 13 - Catch Bolt and Door Claw
Orientation
INSTALLING FIREPLACE
INTO STOVE BODY
1.
2.
Insert
Assembly
Cast Iron
Stove Body
Threaded
Hole
Stove Bottom
Figure 14 - Installing Firebox Into Cast
Iron Stove Body
6
Bolt Stop
Adjusting Nut
Door Claw
Catch Bolt
Door
Carefully lift firebox and place into
stove body from the rear of stove.
Using screws provided, attach firebox
to back of stove.
Screw
105500