GAS GAS ENDUCROSS EC - 2007 User Manual page 37

(A). Hydraulic rod.
- Pull the hydraulic rod (A) out slowly.
- At this time, the fork oil pours out of the hydraulic rod hole, keep
it raised to let it drain until it stops.
- Install the fork spring (1) inside the fork tube.
- Tighten the suspension spring and insert the wrench (5) in the
locknut (2) to lock the cap (3).
- Install the suspension cap (3) in the fork tube and tighten it to 29
Nm.
- Mount the other fork.
- Install the parts removed.
Suspension tube spring
Different springs are available in accordance with the rider´s weight
or the road conditions.
- Harder springs make the fork stiffer, and rebound action quicker.
- Softer springs make the fork softer, and rebound action slower.
Suspension top bridge position adjustment
Make sure the front tire does not rub against the fender when the
fork tubes are compressed fully. Make this adjustment to a minimum
of 5 mm.
The suspension tubes, both right and left, must be adjusted evenly.
35
- -
(1). Spring.
(2). Locknut.
(3). Suspension cap.
(4). Cap wrench.
(5). Locknut wrench.
CAUTION