GAS GAS ENDUCROSS EC - 2007 User Manual page 23

WARNING
To prevent severe scalding do not remove the radiator cap or try to
change liquid, when the engine is still hot. Wait until it cools.
Coolant level
- Place the motorcycle in riding position.
- Turn the radiator cap (A) counterclockwise and wait a few seconds
until vapors inside are released. Then push and turn it further in
the same direction and remove the cap.
NOTE
Check the level when the engine is cold.
- Check the coolant level. The coolant level should be just at a level
below de cap rubber seal.
- If the coolant level is low, add the correct amount of coolant
through the filler opening.
Total quantity
Mix antifreeze and distilled water 1:1 (distilled water 50%, antifreeze
50%).
Capacity: 1.1 L
Coolant Replacement
Coolant should be changed periodically to ensure long engine life.
- Wait for the engine to cool completely.
- Place the motorcycle in riding position.
- Remove the radiator cap.
(A)
- Place a container under the coolant drain screw, and drain the
coolant from the radiator and engine by removing the drain screw
(B) at the bottom of the water pump cover (A). Wash off immediately
any coolant spilled on the chassis, engine, or wheels.
200 / 250 / 300 cc.
21
- -
(1). Coolant level.
(2). Filler opening.
(A)
(B)
125 cc.
(A)
(B)