Storage; Gas Gas Speedo Instructions - GAS GAS EC - 2004 Service Manual

STORAGE

When the motorcycle is to be stored for any lenght of time, it should
be prepared for storage as follows:
- Clean the entire vehicle thoroughly.
- Run the engine for about five minutes to warm the oil shut it off
and drain the transmission oil.
- Put in fresh trransmission oil.
- Empty the fuel from the fuel tank, and empty the carburetor float
bowl. (If left in for a long time, the fuel will deteriorate).
- Remove the spark plug and put several drops of SAE 30 oil into
the cylinder. Kick the engine over slowly a few times to coat the
cylinder wall with oil, and install the plug.
- Lubricate the drive chain and all the cables.
- Spray oil on all unpainted metal surfaces to prevent rusting. Avoid
getting oil on rubber parts or in the brakes.
- Tie a plastic bag over the exhaust pipe to prevent moisture from
entering.
- Set the motorcycle on a box or stand so that both wheels are
raised off the ground. (If this cannot be done, put boards under the
front and rear wheels to keep dampness away from the tire rubber).
- Put a cover over the motorcycle to keep dust and dirt from collecting
on it.
To put the motorcycle back into use after storage.
- Remove plastic bag from exhaust.
- Make sure the spark plug is tight.
- Fill the fuel tank with fuel.
- Check all the points listed in the Daily Pre-ride Inspection Section.
- Perform the General lubrication procedure.

GAS GAS SPEEDO INSTRUCTIONS

The top button is the reset button.
The bottom button is the mode button.
Reset
Mode
The initial display is the clock.(time) if you press mode (btm. button)
the display goes:
1. Speedometer.
2. Speed (Km or miles).
3. Total distance in kmh or miles (this has a memory even if battery
disconnected).
4. Trip distance.
00:00
Speedometer
112
EC 2004 - -
00:00
0
Speed