Sherwood ASW-670 Operating Instructions Manual page 16

Adjusting the tone(bass and treble) and balance
• You can adjust the tone(bass and treble) and the sound volume balance between the left and right speakers as desired.
Select the desired mode
8
At the desired mode, adjust it as desired.
9
Selecting a listening mode
• While playing the selected input source
Listening modes
• Dolby Virtual Speaker
This mode creates a virtual surround sound field as few as two front speakers and subwoofer, allowing you to experience
listening from 5.1 channel speakers.
* Dolby Virtual Speaker Reference("Dolby VS REF")
The width of the front sound image is defined by the actual distance between front speakers.
* Dolby Virtual Speaker Wide("Dolby VS WIDE")
The width of the front sound image seems to extend beyond the front speakers.
• Dolby Headphone("DOLBY HP")
This mode simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel surround sound through 2 channel
headphones, just like listening from 5.1 channel speakers.
• Dolby Virtual Speaker and Dolby Headphone modes are effective not only for 5.1 channel sources but also for stereo(2
channel) sources.
Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic" and the double-D symbol are trademarks of Dolby
Laboratories.
• Virtual Speaker
This mode simulates a virtual 5.1 channel surround sound and includes two listening modes(Virtual Speaker Reference("VS
REF") and Virtual Speaker Wide("VS WIDE") like Dolby Virtual Speaker mode.
• Headphone Sound("HP SOUND")
This mode simulates a virtual 5.1 channel surround sound through 2 channel headphones like Dolby Headphone mode.
• The Virtual Speaker and Headphone Sound modes are effective for stereo(2channel) sources only.
• Each time this button is pressed, the mode changes and is
displayed for several seconds as follows :
TRBL BASS BAL
(Treble) (Balance)
• When the mode display disappears, press this button
again.
• On the remote control, when adjusting the treble or bass,
use the CURSOR UP/DOWN( / ) buttons and when
adjusting the sound volume balance, use the CURSOR
LEFT/RIGHT( / ) buttons.
• To complete the adjustment, repeat the above steps 8 and
9.
Notes:
• Extreme settings at high volume may damage your
speakers.
• In general, we recommend the bass, treble and balance to
be adjusted to 0(flat)level.
• Each time this button is pressed, the listening mode
changes depending on the selected input source as
follows :
In case of selecting DVD
(Dolby VS REF Dolby VS WIDE) or <DOLBY HP>
STEREO
In case of selecting a input source except DVD
(VS REF VS WIDE) or <HP SOUND>
( ) : Possible only when listening via the speakers.
< > : Possible only when listening via the headphones.
16
STEREO