Installation Instruction - Encore ENHWI-1AN4 User Manual

WAN
LAN
(1, 2, 3, 4)
Back Panel Connectors
Button/Port
Reset Reset configurations to default. You would use the reset button only when
a program error has caused your Wireless AP router to hang. Press the
button and hold after 6 seconds.
LAN Ethernet RJ-45 connector, connect to PC with a RJ-45 Ethernet cable.
(1x, 2x, 3x, 4x)
WAN Ethernet RJ-45 connector, connect to WAN access device, such as the
Cable modem or ADSL modem.
DC-9V Power connector, connect to the power adapter (DC-9V) packaged with
the AP router.

Installation Instruction

1) Power off the DSL or Cable modem.
2) Connect computer to the LAN port on the ENHWI-1AN4 Router with Ethernet
cable.
3) Connect the DSL or Cable modem to the WAN port on the ENHWI-1AN4 Router
with Ethernet cable.
4) Power on the DSL or Cable modem first, and then connect power adapter to the
power jack on the rear panel of ENHWI-1AN4 Router and plug the power cable
into an outlet.
5) Check LEDs.
Blinking Data is being sent or received.
On WAN port is successfully connected
Blinking Data is being sent or received.
On LAN port is successfully connected.
Blinking Data is being sent or received.
Description
8
www.encore-usa.com