Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING LOGS ON
MODELS CGS2718N AND
CGS3124N
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Locate pegs on the bottom of back log
(#1). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 16).
2. Locate the notches on the back of the
front log (#2). Slide these notches over
the tabs of the grate base (see Figure 17).
3. Locate the notches in the bottom of the
crossover log (#3). Place the crossover
log on top of the back log and front log.
Make sure the notches of the crossover
log line up with rectangular knobs on
top of the back and front logs (see Fig-
ure 18).
4. Add lava rock around base of heater.
Do not place lava rock on logs or
burner.
104385
Peg
Hole
Figure 16 - Installing Back Log
Notch
Tabs of
Grate Base
Figure 17 - Installing Front Log
13
OWNER'S MANUAL
Crossover
Back Log (#1)
Log (#3)
Notch
Peg
Rectangular
Knob
Figure 18 - Installing Crossover Log
Front Log
(#2)
Notch
Rectangular
Knob
Continued
Advertisement
Table of Contents
