Introduction; Unpacking; Overview - Martin Audio WT UB Manual

Hide thumbs Also See for WT UB:
Table of Contents

Advertisement

<
CONTENTS
Standards Applied
1
Thank you for purchasing a Martin Audio Wavefront Theatre Series product.
The Theatre Series is a dedicated range of powerful yet compact
loudspeakers designed to meet the unique demands of theatre sound
reinforcement.
2
Each Martin Audio loudspeaker is built to the highest standard and
thoroughly inspected before it leaves the factory. After unpacking the
system, examine it carefully for any signs of transit damage and inform your
dealer if any such damage is found. It is suggested that you retain the
original packaging so that the system can be repacked at a future date if
necessary.
Please note that Martin Audio and its distributors cannot accept any
responsibility for damage to any returned product through the use of non-
approved packaging.
3
The Wavefront Theatre WT UB loudspeaker has been specifically designed
for under-balcony use in theatres and infill in venues requiring extremely
wide horizontal coverage.
The WT UB loudspeaker provides sound reinforcement for speech and
music with exceptionally consistent tonal balance over the whole of its
coverage angle. It also shares the same tonal characteristics as the larger
members of the WT range, the WT2 and 3.
The unusual driver complement and geometry is responsible for the uniform
coverage of the enclosure. A triple soft dome, high frequency line array
coupled with a proprietary diffusion phase plug gives very wide horizontal
and tight vertical dispersion. Its narrow width allows minimal separation
between the two 6.5" (165mm) cone drivers. This factor and the drivers' 60˚
splay are responsible for the seamless horizontal coverage of the WT UB.
The two 6.5" (165mm) drivers feature 1.5" (38mm) voice coils and an
innovative heat exchange system to reduce power compression. A
combination of ferrofluid and a rear mounted heatsink cools the high
All material © 2007. Martin Audio Ltd. Subject to change without notice.
>
PRINT
This equipment conforms to the requirements of the
EMC Directive 89/336/EEC, amended by 92/31/EEC
and 93/68/EEC and the requirements of the Low
Voltage Directive 73/23/EEC, amended by 93/68/EEC.
EMC
Emission
Immunity
Electrical Safety

INTRODUCTION

UNPACKING

OVERVIEW

Martin Audio – WT UB
EN55103-1:1996
EN55103-2:1996
EN60065:1993
2
GUIDES

Advertisement

Table of Contents
loading

Table of Contents