Connecting With A Computer Equipped With An Analog Rgb; Output; Connecting With Hd-Sdi Equipment - Sony SRX-S105 Operating Instructions Manual

Left side
INTER LOCK ETHERNET RS232C
DVI-D connector
DVI cable
(not supplied)
to DVI output
Computer
Notes
• According to the input signal type, set "Signal Mode" on
"Input Source" in the PICTURE CONTROL window of
the SRX Controller. (page 26)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
DVI-D AUX
AUX connector
Connecting with a Computer
Equipped With an Analog RGB

Output

Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a computer.
Left side
DVI-D
R(P r /C
IN
INTER LOCK ETHERNET RS232C IN
Computer
Note
Select "RGB" in "Signal Mode" of "Input Source" in the
PICTURE CONTROL window.
For details, see page 26.

Connecting with HD-SDI Equipment

Attach the optional LKRI-002 HD-SDI (4:2:2) or LKRI-
003 HD-SDI (4:4:4) input board to the input board
attachment part, and connect the HDCAM recorder/player.
The illustration below shows an example with the LKRI-
002 attached on INPUT B.
AUX
r ) G(Y/Y) B(P b /C b ) HD VD
OUT
OUT
R/G/B/HD/VD
connectors
Monitor cable (not supplied)
to monitor output
Connecting the Projector
19