Picture Control Window; Board; Input Source - Sony SRX-S105 Operating Instructions Manual

Note
When you click the FUNCTION button to switch to
another FUNCTION setting, the picture will be cut off for
up to about 10 seconds. The picture with the selected
FUNCTION setting will then appear on the screen.
About the items that cannot be adjusted
Items that cannot be adjusted depending on the input signal
are not displayed in the window.
For details, see "Input Signals And Adjustable/Setting
Items" on page 31.
26

PICTURE CONTROL Window

PICTURE CONTROL
Window
The PICTURE CONTROL window is used to select the
input source or to adjust the picture quality.
When the screen mode is set to "dual screen" or "quad
screen," the items can be independently adjusted for each
input channel displayed on the screen.

Board

Shows the input board installed in the relative input board
slot of the projector. If you select INPUT A, "LKRI-004"
is always displayed.

Input Source

Signal Mode: Click to open the drop-down list to
select the type of signal input from equipment
connected to INPUT A of the projector or to the
optional input board.
When a signal is input from INPUT A or when
the LKRI-004 is installed
Select the input signal type of progressive DVI
signals.
When used in normal, select "8bit Single Full," which
is compatible with DVI1.0 standard and the signal
level is Full Range compliance.
When the DTV signal is input, select "8bit Single
Limited," which is compatible with DVI1.0 standard
and the signal level is Limited Range compliance.