Denon AVR-4800 Operating Instructions Manual page 37

System call function
• The included remote control unit is equipped with a system call function for transmitting multiple remote control signals when a single button
is pressed (this is often referred to as a "macro" function).
This function can be used to turn on the amplifier's power, select the input source, turn on the monitor TV's power, turn on a source
component's power and start playback, etc., all at the touch of a button.
(1) System call buttons
The buttons that can be used for the system call function are shown on the table below.
A series of up to 10 operations can be performed with the POWER ON and OFF buttons, and a series of up to 5 operations can be performed
with other buttons.
System call signals are already preset at the buttons indicated in the shaded section. System call signals can also be stored at any button on
the remote control unit, including the buttons in this section. (See page 38.)
No. Stored
Button
transmissions operation 1
POWER OFF
10
(key 3)
POWER ON
10
(key 4)
Receiver
DVD (key 5) 5
power on
Receiver
VDP (key 6) 5
power on
TV/DBS Receiver
5
(key 9) power on
V.AUX Receiver
5
(key 10) power on
VCR-1 Receiver
5
(key 13) power on
Receiver
CD (key 14) 5
power on
(2) Using the system call function
1 Press the system call button.
• The LEARNED/TX LED flashes for 5 seconds.
2 Press the button at which the desired system call signals are
stored while the LEARNED/TX LED is flashing.
• The preset signals or the signals you have stored at that
button are transmitted in succession.
Stored Stored
operation 2 operation 3 operation 4
Receiver
DVD player
input source
(DVD) TV power on
switched to
power on
DVD
Receiver
LD player
input source
(VDP) TV power on
switched to
power on
VDP
Receiver
input source
TV power on
switched to
TV/DBS
Receiver
input source
TV power on
switched to
V.AUX
Receiver
Video (VCR)
input source
TV power on
switched to
power on
VCR-1
Receiver
input source
switched to
CD
CALL
Stored Stored Stored
operation 5 operation 6
DVD player
(DVD)
playback
LD player
(VDP)
playback The system call signals for the POWER OFF and
POWER ON buttons are transmitted from the remote
control unit approximately once every second.
The signals for the other buttons (DVD, VDP, TV/DBS,
V.AUX, VCR-1 and CD) are transmitted approximately
once every 1.5 seconds.
Video (VCR)
playback
2
Stored Stored Stored
operation 7 operation 8 operation 9
1
RC-869
START LEARNED/TX
SYSTEM CALL POWER
SET CALL OFF ON / SOURCE
DVD VDP TUNER SHIFT
1 2 3
TV/DBS V.AUX PHONO
4 5 6
VCR-1 CD MD / TAPE-1 CHANNEL
7 8 9
VCR-2 TAPE-2 MON
TV/VCR
+10 0
A / B
VOLUME DISC SKIP+
DOLBY / DTS
HOME THX CINEMA SURROUND DIRECT
DSP SIMULATION 5CH / 7CH STEREO STEREO
MASTER VOL.
INPUT MODE ANALOG EXT.IN
DECK MD
AUDIO CD MULTI MUTING
AVR/AVC VIDEO DVD TV
VDP VCR
SYSTEM SURROUND
TUNING SETUP PARAMETER
TITLE MENU/GUIDE
BAND
CH SELECT
ENTER
MODE
SELECT
Stored
operation 10
37