This connector supports the optional wireless transmitting and receiving infrared
module. You must configure the setting through the BIOS setup to use the IR
function.
(13) CD Audio-In Headers (4-pin): CDIN1, CDIN2
CDIN1 and CDIN2 are the connectors for CD-Audio Input signal. Please
connect it to CD-ROM CD-Audio output connector.
(14) AUX-In Headers (4-pin): AUX-IN
2-7 Starting Up Your Computer
1. After all connection are made, close your computer case cover.
2. Be sure all the switch are off, and check that the power supply input voltage is
set to proper position, usually in-put voltage is 220V∼240V or 110V∼120V
depending on your country's voltage used.
3. Connect the power supply cord into the power supply located on the back of your
system case according to your system user's manual.
IR
CIR
1
6
VCC
N.C
IRRX
GND
IRTX
5
10
Infrared Module Headers
1
CDIN1
CD Audio-In Headers
1
AUX IN
AUX In Headers
22
IR: (Pin1 ∼ Pin5) for Standard IR
NC
CIRRX
CIR: (Pin6 ∼ Pin10) for Consumer IR
IOVSB
NC
NC
CDIN2
1
4
4
4