The Roll Is Empty; Rewinding Error; Turn On The Media Take-Up Unit; Media Take-Up Unit Ready - Canon 2163B002 User Manual

Messages regarding paper

The roll is empty.

There is no more paper left on the roll.

Rewinding error.

There is some foreign object near the Media Take-up
Unit sensor and the roll cannot be detected.
The Media Take-up Unit sensor is soiled and the roll
cannot be detected.
The roll is out of range of detection of the Media
Take-up Unit sensor.
The Media Take-up Unit sensor is damaged.
* Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing
not to stop, set Skip Take-Up Err to On.

Turn on the media take-up unit.

The Media Take-up Unit was off when you selected
Enable for Take-up Reel .

Media take-up unit ready.

The Take-up Reel setting in the printer MAIN MENU
was changed from Enable to Disable , but a print job
was received before the roll was removed.
776 Error Message
Cause
Cause
Cause
Cause
Corrective Action
Follow the steps below to replace the used roll with a
new roll of the same type and size.
1.
Remove the roll.
(→P.186)
(→P.181)
2.
Load the new roll.
(→P.182)
3.
If no barcode was printed on the roll, specify the
paper type.
(→P.188)
4.
If no barcode was printed on the roll, specify the
paper length.
(→P.189)
Corrective Action
Remove the foreign object near the sensor.
Wipe the sensor with a dry cloth to clean it.
Reload the roll. (→P.182)
Contact your Canon dealer for assistance.
Corrective Action
Turn the Media Take-up Unit on.
Corrective Action
Press the Stop button and stop printing.
The mode switches from take-up mode to regular
mode after you change the Take-up Reel setting in
the MAIN MENU from Enable to Disable and lift the
Release Lever , or after you execute Paper Cutting .
Press the Online button to resume printing.