Table of Contents
Advertisement
SOMETHING WRONG?
Before calling a Service Engineer, please check through the following lists.
Problem
Nothing works.
Draught from beneath control
panel.
Cooling fan not operating
Oven burner not working
Oven appears to be cooking at too
high a temperature.
If you have been through the above list and there is still a problem; You should identify your Service
Agent using the list on the back page and contact your Local Service Office.
28
THERE MAY BE NOTHING WRONG.
Check
If the clock display is blank.
Then it is likely that there is no electricity supply to your oven.
Check: (i)
That the main cooker wall switch is turned on.
(ii) Check other appliances to see if you have a power cut.
(iii) Check the main circuit breaker for the property.
A gentle flow of air will be blown from beneath the control panel when
the appliance is used. If the appliance is still warm, this cooling fan may
continue to run, or restart itself after all controls have been turned off.
The fan will stop once the appliance has cooled.
If no air is blown from below the control panel when the controls are
switched on and you have checked through the " Nothing works "
section above, then the cooling fan may be faulty. In this case you should
turn off the appliance and contact your service agent to arrange for a
repair.
Note that the oven burners only operate when the door is closed to
ensure safe operation and avoid wasting heat. With the door closed the
oven burner will ignite.
It may be necessary to turn to a lower setting than shown on the cooking
chart or recipe as results depend on personal tastes.
If the oven appears to be cooking at too high a temperature than
previously, and turning down the thermostat has no effect, then the
thermostat may be faulty and you should contact your service agent.
Advertisement
Table of Contents
