Set Active Effect By Id - Lexicon RV8 V1.0 - SERIAL COMMUNICATIONS PROTOCOL DEFINITION REV 1-7 Manual

Lexicon, Inc.
RV-8 Serial Communications Protocol
7.3.26.1 Packet Description
Application Header:
Command MC_CMD_SET_FRONT_BACK_BALANCE
Data Count 1
Application Data:
Data[0]
7.3.26.2 Data Description
Value:
Data Type:
Max:
Min:
7.3.26.3 RV8 Response
The RV8 will assign the value from the packet to the front/back balance.
7.3.26.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the RV8 will ignore the command
and transmit a NAK command with an error code DC_INVALID_DATA.

7.3.27 Set Active Effect by Id

This command requests the RV8 to set the active effect to the value in this packet.
7.3.27.1 Command Packet Description
Application Header:
Command
Data Count
Application Data:
Data[0]
7.3.27.2 Data Description
EffectId:
Data Type:
Definition/Conversion:
7.3.27.3 RV8 Response
The RV8 will load the desired effect.
7.3.27.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the RV8 will ignore the command
and transmit a NAK command with an error code DC_INVALID_DATA.
© 2004 Lexicon, Inc. All rights reserved.
Value
Signed 8 bit integer (2's compliment)
+16 (0x10) (Full Front)
-16 (0xF0) (Full Back)
MC_CMD_SET_EFFECT
1
EffectId
Unsigned 8 bit integer
Appendix J RV8 Mode Ids
Printed on: 01/18/05
0x42
0x01
nn
0x43
0x01
nn
33 of 74