Dvd Audio - Denon DVD-3910 Operating Instructions Manual

NOTES:
• When DENON LINK is set, the down-mixed audio signals are output only from the left and right terminals and front left and front
right terminals.
If you want to use the analog terminals, set to "DENON LINK" to "OFF".
• When using the DENON LINK connector, the "AUDIO CHANNEL", "DIGITAL OUTPUT", "LPCM (44.1kHz/48kHz)", "SOURCE
DIRECT" and "BASS ENHANCER" settings under "AUDIO SETUP" and the "HDMI AUDIO SETUP" and the "IEEE1394"
settings under "DIGITAL INTERFACE SETUP" at "SETUP" cannot be made.
The digital output cannot be turned off even by setting "PURE DIRECT SELECT" to "ALL OFF" or selecting a mode for which
the digital output is set to off. (See pages 47, 48.)
• The DVD-3910's speaker settings are invalidated when the DENON LINK connector is connected.
• When the DENON LINK 2nd connection, Super Audio CD's signals are not output from the DENON LINK connector. Please use
the analog audio output terminals.
(8) IEEE 1394 connections
The simple connection of one IEEE 1394 cable permits high quality digital transfer of the following between devices having IEEE 1394
connectors: the audio of DVD video, DVD audio that up until now could only be connected by 5-conductor audio cable in an analog
connection, or Super Audio CD and other multi-channel audio. (unless DENON LINK connections)
(IEEE 1394 is an international standard established by the Institute of Electrical and Electronics Engineers, Inc. of the U.S.)
DVD-3910
Front speaker (left)
Surround speaker (left)
Center speaker
SURROUND MODE MULTI FUNCTION
DOLBY DTS WIDE 5CH / 7CH DSP MODE FUNCTION CONTROL
STEREO SURROUND SURROUND SCREEN STEREO SIMULATION STATUS SELECT
CINEMA / 6.1 / 7.1 VIDEO TONE REC /
ANALOG EXT. IN MUSIC SURROUND ON / OFF DEFEAT M-ZONE 1 M-ZONE 2
INPUT REC SELECT / M-ZONE
AV amplifier with IEEE 1394 terminals
To power outlet
Front speaker (right)
Subwoofer
Surround speaker (right)
ENGLISH
17