NETGEAR FVX538v1 - ProSafe VPN Firewall Dual WAN Planning Manual page 6

Network Planning Guide for ProSafe VPN Firewall Router FVX538
Table 1-1. Object Descriptions (continued)
Object Activity
WAN Ports Two RJ-45 WAN ports N-way automatic speed negotiation, Auto MDI/MDIX.
and LEDs
Link/Act LED
On (Green)
Blinking (Green)
Off
100 LED
On (Green)
Off
Active LED
On (Green)
On (Amber)
Off
LAN Ports 8-port RJ-45 10/100
and LEDs Mbps Fast Ethernet
Switch
Link/Act LED
On (Green)
Blinking (Green)
Off
100 LED
On (Green)
Off
DMZ (port 8)
On (Green)
Off
Gigabit Port Gbit RJ-45 connector
and LEDs
Link/Act LED
On (Green)
Blinking (Green)
Off
Speed LED
On (Green)
On (Amber)
Off
Console DB9 male connector
Port
Factory —
Defaults
1-2
Description
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
The WAN port has a valid Internet connection.
The Internet connection is down.
The WAN port is either not enabled or has no link.
N-way automatic speed negotiation, auto MDI/MDIX.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
Port 8 is operating as a dedicated hardware DMZ port.
Port 8 is operating as a normal LAN port.
Port for connecting to a gigabit Ethernet device.
The LAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the LAN port.
The LAN port has no link.
The LAN port is operating at 1,000 Mbps.
The LAN port is operating at 100 Mbps.
The LAN port is operating at 10 Mbps.
Port for connecting to an optional console terminal. Default baud rate
is 9,600; pinouts: (2) Tx, (3) Rx, (5) and (7) Gnd.
Factory Defaults reset push button (see
page 1-4 for the factory defaults).
October 2004
"Default Factory Settings" on
Introducing the FVX538