Using The Connection Wizard To Connect To A Network - NETGEAR WG511NA - Wireless G Pc Card User Manual

Using the Connection Wizard to Connect to a Network

During the WG511 v2 software installation the Connection Wizard lists the available networks.
After installation you can use the Connection Wizard at any time to view the available networks
and select the one that you want to use.
Note: Make sure that you know the security settings for the network that you want to use. For
example, if WEP is used then you need to know the WEP key. If you use secure networks
frequently, set up profiles for each network with the wireless configuration settings. See
up an Access Point Mode Profile" on page 3-3
page 3-5.
To use the Connection Wizard
1. From the Networks page, click the Connection Wizard button.
The Connection Wizard opens as shown below:
Figure 3-9: Connection Wizard
2. Select a network from the drop down list, and click Next.
3. Follow the steps of the Connection Wizard to specify the wireless security if used, and to
create a profile.
4. Review you settings, and click Finish.
The Connection Wizard initiates your wireless connection.
Configuring Wireless Adapter Settings
June 2005
User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511 v2
or "Setting up an Ad Hoc Mode Profile" on
"Setting
3-15