Front Panel - Lexicon I-ONIX FW810S Owner's Manual

front Panel

1
1. InPutS 1 anD 2 (MIc/InSt 1 anD MIc/InSt 2)
These balanced inputs accept XLR or 1/4" connectors, and support mic,
line, and instrument level sources (including guitars).
2. InStruMent ButtOn/LeD
Press when an instrument level source (such as a guitar) is connected to the
corresponding input (1 or 2). The button illuminates when activated.
3. +48V ButtOn/LeD
Each of these buttons enables the phantom power to the corresponding
inputs pairs. Dynamic microphones do not require phantom power to
operate, but are not harmed by it. Most condenser microphones do require
phantom power to operate. If you are unsure about the phantom power
requirements for your microphone, consult your microphone's documenta-
tion or contact the manufacturer. This switch should be OFF if you are
connecting any line-level source to the Mic/Inst or Mic Pre jacks.
4. DynaMIcS LeDS anD InPut LeVeL LeDS
The top three rows indicate what dynamics are active for each input. The
bottom three rows indicate signal presence (green) and level (yellow and
red) for each input.
5. fIrewIre LeD
tM
Indicates when a FireWire
6. POwer LeD
Indicates when the I-ONIX FW810S is turned on.
7. GaIn knOBS 1 anD 2
These knobs adjust the input gain levels for Mic/Inst 1 and Mic/Inst 2.
8. GaIn knOBS 3 – 8
These knobs adjust the input gain levels for Mic Pre 3 – 8 (the inputs
located on the back panel).
9. heaDPhOne OutPut Jack
Connect headphones here.
10. heaDPhOne LeVeL knOB
Adjust headphone output signal level here.
11. MaIn OutPutS LeVeL knOB
Adjust the main output signal level here.
2
3
7
TM connection is present.
4
8
5
6
9 10 11
3