The Front Panel; Mic 1-2 Gain; Line 1-2 Gain; Peak Leds - Lexicon LAMBDA Owner's Manual

The Front Panel

THE FRONT PANEL

Peak LEDs

For the cleanest
recording,
adjust the Gain
so the level
reaches at least
-6 on the Input
Bargraph Meter,
but never lights
the Clip LED
on the loudest
sound you'll be
recording. If you

MIC 1-2 GAIN

see the Peak LED
These knobs adjust the input gain levels of the Mic 1 and Mic 2 inputs.
light constantly,
turn the Gain
knob down until

LINE 1-2 GAIN

it flashes only
These knobs adjust the input gain levels of the Line 1 and Line 2 inputs.
occasionally, on
the loudest part of
PEAK LEDS
the performance.
These LEDs light when the input signal is within 5 dB of analog clipping. If the Peak
LEDs flicker occasionally, the signal is approaching clipping levels, but this does not
necessarily indicate distortion or actual clipping.
DO NOT TURN
DOWN A GAIN

MONITOR ASSIGN

CONTROL TO
These buttons select whether a pair of analog audio sources will be heard in stereo
GET THE RIGHT
or mono in the Direct Monitor Mix. In Stereo mode, the left inputs (Mic 1, Line 1)
MIX IN YOUR
are routed to the left monitor and right (Mic 2, Line 2) inputs are routed to the right
HEADPHONES
monitor.
OR MONITORS
WHILE
In Mono mode, you'll hear the selected inputs in the center of the Direct Monitor Mix
RECORDING. USE
through the Headphone or Line outputs.
Monitor Mix
THE
When a Monitor switch is in Mono, it does not change the signals going to the
CONTROL FOR
computer in any way — they will still be separate and stereo in the computer.
THIS PURPOSE.
Monitor Assign
Line 1 Gain
Monitor Assign
Monitor Mix Control
USB LED
1/4" Instrument Input Jack
3
Mic 1-2 Gain
Mic 1
Mic 2
Peak
Peak
Monitor
Stereo Mono
Line 1
Line 2
Peak
Peak
Monitor
Stereo Mono
Monitor Mix Output Level
Direct Playback
Clip
-6
-20
-40
Instrument USB +48V
Peak LEDs
Line 2 Gain
Output Level
Input Bargraph Meter
+48V Phantom Power LED
1/8" Headphone Output Jack