Lexicon CP-1 PLUS V2.0 Owner's Manual page 19

Connection
and
Calibration
NOISE
{
When calibrating right, if your left
ear is in the silent band, the speaker
angle is correct.
If the two silent bands are too close,
lower the Speaker Angle; if they are
too far apart, raise the Speaker Angle.
Page 14
go on to step 6; otherwise, perform step 5.
5. Push PARAM twice so the display reads: SPEAKER ANGLE. If the sweet
spot from step 2 (LEFT ONLY) is to the left of the sweet spot from step
SILENCE
4 (Right ONLY), push PARAM UP once. If the the step 2 sweet spot is to
the right of the step 4 sweet spot, push PARAM DOWN. Push PARAM
to return to CALIBRATE RIGHT ONLY and go back to step 2.
6. Adjust your chair so the single sweet spot is in the center, or use PARAM
to get to LISTENER POS and adjust this parameter to move the sweet
spot to where you want it. Use PARAM to step to CALIBRATE and push
PARAM DOWN until the calibration signal goes off.
The Panorama mode is now calibrated. To store it, see page 36. Use PARAM
to display the final values of LISTENER POS and SPEAKER ANGLE. Note
these values and use them for all forms of Panorama, including the Pano-
rama subsections of the CONCERT HALL modes.
Lexicon