Lexicon CP-1 PLUS V2.0 Owner's Manual page 15

Digital audio environment processor version 2.0
Table of Contents

Advertisement

Connection
and
Calibration
Connecting the CP-1
in a Tape Monitor Loop
Audio Inputs
Audio Outputs
Page 10
VCR, TV, VIDEO
CONTROL CENTER
Note
If you have a receiver with no external access to the preamplifier outputs (or
you wish to use the tape monitor loop on your preamp), you can use a tape
output or external processor loop to the CP-1. However, any change in the
receiver's volume control after the system is adjusted will upset the balance
between the main and auxiliary speakers. If you are using this configura-
tion, you should now turn the receiver's volume control all the way down.
If there was a tape deck previously connected to your receiver's monitor
loop, connect it to the CP-1's tape outputs and inputs.
Turn off ALL audio and video components, including individual power
amplifiers. (Unplug any preamps and power amps that don't have
switches.) Locate the gain trim potentiometers on the CP-1 rear panel; these
are knobs at the top of the panel, marked REAR, SIDE, MAIN, CENTER and
SUB. Turn each one all the way down (counterclockwise as viewed from
the back).
Connect the main outputs of your audio preamplifier or the preamplifier
output of your receiver to Input I on the CP-1.
Note
Inputs I and II are electrically identical and can be used interchangeably.
The CP-1 will also act as a line-level preamp with three inputs (including the
built-in tape monitor loop) if you wish to connect, for example, the audio
outputs from a TV receiver/monitor, a CD player and a VCR directly to it.
Connect the CP-1's MAIN outputs to your main stereo channels. Connect
any additional amplifier/speaker combinations to the remaining outputs
on the CP-1. Refer to page 19 for information regarding subwoofer connec-
tion.
Locate the button below the SUB potentiometer marked CENTER/OUT,
PHANTOM/IN. If you have no center front speaker, push it in; if you have
a center channel, make sure this button is in the out position.
TAPE
INTEGRATED AMP,
OUT
PREAMP or RECEIVER
I
CP-1
INPUTS
II
AUDIO
OUT
TAPE
OUT/IN
VCR
or
CASSETTE DECK
Lexicon
TAPE
IN
CENTER
AMP
MAIN
CENTER
REAR
REAR
AMPS
SIDE
SUB
WOOFER
SIDE
AMPS
SUBWOOFER
AMP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-1 plusCp-1

Table of Contents