Repeater Operation; Automatic Repeater Shift (Ars); Manual Repeater Shift Activation - Yaesu FT-250R Operating Manual

Basic Operation
The ARS (Automatic Repeater Shift) feature in the FT-250R provides repeater shift of
the transmit frequency whenever you are tuned to a standard repeater subband (see dia-
gram below). When enabled, a small "–" or "+" will be displayed in the upper left-hand
corner of the display, signifying that repeater shift is active, and closing the push-to-talk
switch changes the display to the (shifted) transmit frequency.

Automatic Repeater Shift (ARS)

To re-enable ARS:
Press the [ F/L ] key, then immediately press the [ 0 ( SET ) ] key to enter the Set mode.
Rotate the DIAL to select Menu Item #2 ("ARS
Press the [ F/L ] key to enable modification of the current setting.
Now rotate the DIAL to select "ON" (to enable Automatic Repeater Shift).
Press the PTT key to save the new setting and exit to normal operation.
For repeaters using 1750-Hz burst tone access, you can configure the switch below
the PTT to send the access tone when this switch is pressed. See page 14 for details.

Manual Repeater Shift Activation

When a repeater shift is active, either "–" or "+" appears in the display. If neither appears
when tuned to a repeater output frequency, you can activate the shift manually:
Press the [ F/L ] key, then immediately press the [ 0 ( SET ) ] key to enter the Set mode.
Rotate the DIAL to select Menu Item #3 ("RPT
Press the [ F/L ] key to enable modification of the current setting.
Rotate the DIAL to select the desired repeater shift direction (-RPT
Press the PTT key to save the new setting and exit to normal operation.
8
R O
EPEATER PERATION
ARS"). ARS ARS
ARS
Tone Burst
RPT RPT
RPT"). RPT
+RPT or SIMP
-RPT, +RPT -RPT -RPT -RPT +RPT +RPT +RPT
FT-250R O
PERATING
SIMP). SIMP SIMP SIMP
M
ANUAL