Cloning - Yaesu FT-250R Operating Manual

The FT-250R includes a convenient "Clone" feature, which allows the memory and con-
figuration data from one transceiver to be transferred to another FT-250R. This can be
particularly useful when configuring a number of transceivers for a public service opera-
tion. Here is the procedure for Cloning one radio's data to another:
Turn both radios off.
Connect the optional CT-27 cloning cable between the MIC/SP jacks of the two ra-
dios.
Press and hold the PTT and LAMP key while turning the radio on.
Rotate the DIAL to select "CLONE
Press the [ F/L ] key, to enter the CLONE mode. "CLONE
of both radios when the Clone mode is successfully activated in this step.
On the Destination radio, press the MONI key ("SAVING
Press the PTT key on the Source radio; "SENDING
and the data is transferred.
If there is a problem during the cloning process, "C-ERROR
your cable connections and battery voltage, and try again.
If the data transfer is successful, the Destination radio will return to normal operation;
Turn both radios off and disconnect the CT-27. You can then turn the radios back on,
and begin normal operation.
FT-250R O
PERATING
CLONE." CLONE CLONE
CLONE
Optional Cloning Cable "CT-27"
M
ANUAL
CLONE" will appear on the displays
CLONE CLONE CLONE
SAVING" will appear on the LCD).
SAVING SAVING SAVING
SENDING" will appear on the Source radio,
SENDING SENDING
SENDING
C-ERROR" will be displayed. Check
C-ERROR C-ERROR C-ERROR

Cloning

31