Adjusting Dry Path Global Mix - DigiTech S100 User Manual

S-100
To select any one of these five different configurations, simply perform the following procedure:
• Press the <Config> button and the display will briefly read: CF indicating that you are in the configuration select
mode and now the display will appear something like this:
• Now turn the <Program/Data> wheel until the desired configuration appears (C1-5) in the display.
• To exit the Effect configuration menu, simply press the <Program> button where the display will flash the program
number until the program change is stored or until you change to the next program.
Adjusting the Dry Path Global Mix
This editing procedure will allow you to globally turn a Dry signal path Off for use with a mixing consoles' effects sends or
On for use with single instrument input signals (such as guitar, saxophone and others). The procedure is as follows:
• To edit the Dry signal within the effect configuration of the S-100 (turning it On or Off), press the <Mix/MIDI> button
once and the display will briefly read: dr indicating the dry path mix and then On, indicating that the Dry signal is on.
If you wish to turn the dry path off, simply turn the <Program/Data> wheel counter clockwise and the display will
now read:
• This now indicates that the Dry signal has been turned Off creating a 100% Wet signal globally in the S-100. To exit this
mode, press the <Program> button.
Note: The Dry path will automatically be turned off when either a Tremolo, Panner, Vocoder, Compressor, Rotary
Speaker or Reverse Reverb effect is used in a program, since the dry signal is already included in these
effects.
User Guide
Section -2 Operation and Editing
C1
Of
9