Applying Power - DigiTech RP355_E - REV 18-6412V-D Owner's Manual

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
1. Turn the amp volume all the way down.
2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the
RP355.
3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP355's Mas-
ter Level knob (Knob 6) down to "0".
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal
playing level.
5. Gradually increase the RP355's Master Level knob to achieve the desired volume.
4. Turn amp volume up
1. Turn amp volume down
10
2. Connect PS0913B to power jack
EXPRESSION
AMP A-B
DISTORTION BYPASS STOMP Mode DELAY
5. Turn the RP355's Master Level
to the desired listening volume
3. Connect PS0913B
to AC outlet and
turn the RP355's
Master Level to "0"