Slip Clutch - Alamo 00785503C Operator's Manual

SLIP CLUTCH

If a slip clutch is incorporated in the PTO driveline, it is designed to slip, absorb the shock load, and protect the
driveline. This clutch has single disc spring with 6 adjusting nuts.
After the first hour of operation, the slip clutch should be checked for overheating. After this first check, the slip
clutch should be checked weekly or anytime there is overheating. To adjust the disc clutch, tighten the 6 bolts
until Belleville Spring is flat and then loosen each of them 2 turns.
The slip clutch should be checked periodically and adjusted to compensate for wear. The lining plates are 1/8"
thick when new. Replace after 1/32" wear. If the mower has been idle for an extended period of time, or in wet
weather, before operating check to be sure the friction lining plates are not rusted/coroded together. Should
this occur refer to the procedure described in the "Seasonal Clutch Maintenance" section on the next page.
There are two friction lining plates in the slip clutch. These should be checked weekly for oil or grease, wear,
and moisture which could cause corrosion on the drive plates.
All Safety Shields, Guards and Safety devices including (but not lim-
ited to) - the Deflectors, Chain Guards, Steel Guards, Gearbox
Shields, PTO integral shields, and Retractable Door Shields should
be used and maintained in good working condition.
devices should be inspected carefully at least daily for missing or
broken components.
replaced at once to reduce the possibility of injury or death from
thrown objects, entanglement, or blade contact.
RX60/72/84 03/09
© 2009 Alamo Group Inc.
MAINTENANCE
Missing, broken, or
Maintenance Section 5-12
All safety
worn items must be
(SGM-3)