Table of Contents
Advertisement
proGrAmmInG Your
CoffeemAKer
1. Setting the Clock
When the coffeemaker is plugged in, 12:00 will
appear until you set the time.
Entering Time Set Mode
To set the time, hold down either the Hours or
Minutes button until the clock begins flashing
(about 2 seconds). You are now in the Time
Set mode and can operate either button to
achieve the desired setting. The buttons can
be held down to scroll through the digits, or
pressed and released lightly to advance one
digit at a time.
When scrolling, the numbers will advance
slowly at first and then speed up to the rate
of about three per second. When the number
displayed approaches the desired setting,
release the button and press repeatedly to
advance one digit at a time. Be careful to
make sure that "PM" is on if a PM time is
desired.
Exiting Time Set Mode
The Time Set mode can be exited in
one of two ways:
1. Press any button besides the Hours or
Minutes button. This will exit the Time Set
and activate the selected function.
2. Do nothing. If neither the Hours nor Min
button is pressed for a period of five
seconds, the Time Set mode will
be exited.
2. Setting the Program Time
When you press the Program Set button,
it displays the current program time
(default time 12:00 p.m.).
Entering Set Program Time Mode
Press and hold the Program button (about
2 seconds) until the green light and LCD dis-
play begin to flash. This signals that you have
entered the Set Program Time mode. The
desired time can be set by pressing the Hours
and Min buttons to scroll forward through the
digits. Pressing and holding either button will
allow you to scroll continuously, slowly at first,
and then to accelerate to the rate of about three
digits per second. As the desired time setting
approaches, release the button and then press
repeatedly to advance one digit at a time.
8
The coffeemaker will start to brew at the
programmed time. The Program mode cannot
be entered if the coffeemaker is in its brew or
keep warm cycle.
Exiting Set Program Time Mode
Set Program Time may be exited in any
of three ways:
1. Press the Program button. This will cause
the coffeemaker to revert to its previous
state. If it was Off, it will return to the Off
position. If Programmed, it will revert to this
state, and so on. This is a safety feature.
2. Press any other button (except Hours
or Min). Set Program Time will be exited
and the function of that button will
be executed.
3. Do nothing. If neither the Hours nor
Min button is pressed for a period of five
seconds, the Set Program Time mode
will be exited and the programmed setting
will be in effect.
3. Programming
Automatic Shutoff Time
The Automatic Shutoff Time can be pro-
grammed anywhere from immediate shutoff
after completion of the brew cycle up to four
hours. When the coffeemaker shuts itself off,
two tones will sound. Two hours is the default
time. The 0:00 setting shuts the unit off imme-
diately after brewing is complete. To check
the current setting, press and hold the On/Off
button and the Automatic Shutoff Time will be
displayed.
To change the preset time, press and hold
the On/Off button until the red power
light and LCD display begin to flash.
This signals that you have entered the
Set Automatic Shutoff mode.
Press the Hours and Min buttons
to scroll forward through the digits until
desired time appears. The first setting which
appears is preset at 2:00. When it's at 4:00,
the next press key of Hour will roll back
to 0:00, since four hours is the maximum
Automatic Shutoff setting. Pressing and
holding either button will allow you to scroll
continuously, slowly at first, and then to
accelerate to the rate of about three digits
per second. As the desired time setting
approaches, release the button and then press
repeatedly to advance one digit at a time.
The Automatic Shutoff Time (ASO) may be
Hide quick links:
Advertisement
Table of Contents
