When you turn the camera on and press the
shutter release button halfway down, the
channel is registered on the camera.
2
Next, remove the flash unit from the camera and
place it in the desired position.
● Press the flash mode button (MODE) to display
(P-TTL) if the flash mode was set to the modes
other than P-TTL.
3
Set the zoom position. (Refer to page 21)
● Set the zoom position with (M.Zoom) regardless
of the lens you use.
4
Enable the built-in flash unit of the camera and
display (
) on the LCD panel.
5
Set the sync mode switch of the wireless flash
unit to leading curtain sync (
6
Set the exposure mode of the camera to manual
exposure and the shutter speed faster than X-
sync speed.
● If the shutter speed is the same or slower than
7
● The built-in flash unit is used for control flash
● Refer to camera's operating manual for the
).
the X-sync speed of the camera, the flash will be
set to P-TTL mode, and when it is faster than X-
sync speed, the flash will be set to high-speed
sync mode.
Confirm that the AF540FGZ and built-in flash unit
are fully charged, and take the photograph.
A lamp on the wireless flash unit will blink.
only. It will not be used for main flash.
operation of the camera.
47