Atomic Clock; Time And Calendar Display Modes; Manual Settings - Honeywell RCW33W - Atomic Wall Clock User Manual

is sufficient enough to keep the clock accuracy within 1 second.
• Make sure the unit is positioned at 8 feet (2 meters) distance from any
interference source such as a TV, computer monitor, microwave, etc.
• Within concrete wall rooms such as basements or office buildings, the
received signal may be weakened. Always place the Atomic Wall Clock
near the window for better reception.

ATOMIC CLOCK

Immediately after establishing communication between the main unit and
remote sensor, the atomic time signal receiver will open and start to search for
the atomic time signal. The search usually takes between 5-8 minutes.
NOTE: Do not press any buttons on the main unit during auto search as it
may interrupt product's operation, and you will need to start set up
procedure again.
Once the atomic time signal is received, the date and time will be set
automatically, and the [ ] icon will appear.
NOTE: It is necessary to set your Time Zone, having in mind that the
default zone is a US Pacific Standard Time (PST). (Refer to MANUAL
SETTINGS section)
If the time signal has not been received in 8 minutes, you may use the MODE
button to set the time and date manually. (Refer to the MANUAL SETTINGS
section).
After the clock is set manually, place the Atomic Wall Clock by the window for
the better reception. The atomic clock receiver is programmed that it will
continue to search for the atomic time signal daily for every hour between 1:00
am and 4:30 am.
Once the time signal has been successfully received, the time and date will be
updated automatically.
13

TIME AND CALENDAR DISPLAY MODES

The Atomic Wall Clock displays current time in two display modes – in
hour-minutes-seconds format and in hour-minutes-day.
The date is displayed in month-date format.

MANUAL SETTINGS

It is necessary to set the desired US TIME ZONE.
TIME ZONE
• Press MODE button once so that the Day of the Week abbreviation is
displayed to the right of the time; for example: pm 2:37tu
• Select the Time Zone by pressing and holding UP ( ▲) button for 3
seconds
• Keep holding UP ( ▲) button until the desired US Time Zone (Pacific,
Mountain, Central or Eastern) is highlighted on the display's US map,
located to the right of the time display and above the day of the week
• Release the UP ( ▲) button. The Time Zone is set
CLOCK
• Press and hold MODE button for 3 seconds: the year will flash. Press
UP ( ▲) or DOWN ( ▼) to change flashing digits.
• After the year is set, press MODE button to confirm and move to the
next parameter (month)
• Continue setting month, date, hour, minutes, language for the day of
the week and temperature in Fahrenheit or Celsius
• Press MODE for the last time to return to the time of day with seconds,
after the last parameter is set
13
14