Table of Contents
Advertisement
is being used.
• Install 2 "AA" size alkaline batteries (not included) matching the
polarities shown in the battery compartment.
• Replace the battery compartment door and secure the screws.
• Secure the remote sensor in the desired location.
MAIN UNIT
• Remove the battery compartment door.
• Install 2 batteries (UM-3 or "AA" size 1.5V) matching the polarity as
shown in the battery compartment.
• Replace the battery compartment door.
LOW BATTERY WARNING
A low-battery indicator [
] will appear next to the indoor or remote data
reading line of the main unit warning that the corresponding batteries need
replacement.
GETTING STARTED
WEATHER DISPLAY
After batteries are installed; remote sensor will transmit temperature data at 45
second intervals. The main unit may take up to two minutes to receive the initial
readings. Upon successful reception, remote temperature will appear next to
the OUT abbreviation on the main unit's display (The main unit will
automatically update readings at 45-second intervals)
After communication between the main unit and remote sensor has been
established, secure the remote sensor in the desired location.
If no signal is received from the remote sensor within two minutes, dashes [- - -]
will be displayed. Press and hold the DOWN ( ) button on the main unit for
9
two seconds to initiate another signal search.
PLACEMENT OF THE UNITS
The main unit can be placed on the wall or any flat surface indoors.
remote sensor can be placed indoors or outdoors, on a flat surface or mounted
on the wall.
REMOTE AND INDOOR TEMPERATURE
The remote temperature information line is located next to the indoor
temperature line of the main unit's display.
The wave icon is located above the OUT abbreviation indicates the reception
status from the remote sensor.
There are three following types of the reception status may be displayed:
The unit is in a searching
mode.
Temperature reading is
securely registered.
No signals detected.
NOTE: If the indoor or remote temperature goes above or below operating
range stated in specifications, the main unit's display (weather) will show
dashes "- - -" on the corresponding line.
WEATHER FORECAST
This unit is capable of detecting the atmospheric pressure changes. Based on
collected weather data, it forecasts the weather for the next 12 to 24 hours.
9
The
- - -
10
Hide quick links:
Advertisement
Table of Contents
