Sign in today to find solutions:

Don't have an account? Sign up

Honeywell RCW33W - Atomic Wall Clock User Manual

User manual.

 
Honeywell
Atomic Wall Clock
(RCW33W)
USER MANUAL
TABLE OF CONTENTS
INTRODUCTION
PRODUCT OVERVIEW
BEFORE YOU BEGIN
BATTERY INSTALLATION
LOW BATTERY WARNING
GETTING STARTED
PLACEMENT OF THE UNITS
REMOTE AND INDOOR TEMPERATURE
WEATHER FORECAST
LOST COMMUNICATION
TRANSMISSION COLLISION
WWVB RADIO CONTROLLED TIME
ATOMIC CLOCK
TIME AND CALENDAR DISPLAY MODES
MANUAL SETTINGS
PRECAUTIONS
TROUBLESHOOTING
SPECIFICATIONS
FCC STATEMENT
DECLARATION OF CONFORMITY
STANDARD WARRANTY INFORMATION
2
3
4
7
8
9
9
10
10
10
11
12
12
13
14
14
15
16
17
18
19
20
Next page ->

Summary of Contents

  • Page 1

    GETTING STARTED PLACEMENT OF THE UNITS REMOTE AND INDOOR TEMPERATURE WEATHER FORECAST LOST COMMUNICATION TRANSMISSION COLLISION WWVB RADIO CONTROLLED TIME ATOMIC CLOCK Honeywell TIME AND CALENDAR DISPLAY MODES Atomic Wall Clock MANUAL SETTINGS PRECAUTIONS TROUBLESHOOTING SPECIFICATIONS FCC STATEMENT DECLARATION OF CONFORMITY...

  • Page 2

    INTRODUCTION PRODUCT OVERVIEW MAIN UNIT Thank you for selecting the Honeywell Atomic Wall Clock. This device combines precise time keeping with monitoring and displaying the weather FEATURES • Time automatically sets to the US Atomic Clock conditions from one remote location.

  • Page 3

    FRONT/REAR VIEW D. DOWN ( ▼) button • Decreases the parameters • Activates manual remote channel search BATTERY COMPARTMENT • Accommodates 2 (two) UM-3 or AA 1.5V alkaline batteries F. UNFOLDING TABLE STAND • Holds unit in upright position on a flat surface G.

  • Page 4

    • Flashes twice when battery power is low. within the effective transmission range of 100 feet (30 meters). • The remote sensor can be placed indoors or outdoors, depending B. BATTERY COMPARTMENT • Holds two AA-size batteries on the area where the temperature is intended to be measured. If C.

  • Page 5

    is being used. two seconds to initiate another signal search. • Install 2 “AA” size alkaline batteries (not included) matching the PLACEMENT OF THE UNITS polarities shown in the battery compartment. • Replace the battery compartment door and secure the screws. The main unit can be placed on the wall or any flat surface indoors.

  • Page 6

    • Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor LED indicator will flash showing transmission of the signal. • Remove the batteries from the main unit and reinstall them in the same manner.

  • Page 7

    is sufficient enough to keep the clock accuracy within 1 second. TIME AND CALENDAR DISPLAY MODES • Make sure the unit is positioned at 8 feet (2 meters) distance from any interference source such as a TV, computer monitor, microwave, etc. The Atomic Wall Clock displays current time in two display modes –...

  • Page 8

    TROUBLESHOOTING Check here before contacting customer service. PRECAUTIONS Issue Symptom Solution This product is engineered to give you years of satisfactory service if handled Main unit US Atomic Time Place unit by the window and carefully. Here are a few precautions: signal is not received keep it there overnight •...

  • Page 9: Fcc Statement

    FCC STATEMENT SPECIFICATIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the Main Unit Indoor Temperature following two conditions: (1) This device may not cause harmful interference, Proposed operating range: 23.0°F to 122.0°F (-5°C to +50°C) and (2) This device must accept any interference received, including Temperature resolution: 0.2°F (0.1°C) User-selectable (°F or °C) temperature display...

  • Page 10: Declaration Of Conformity

    The information above is not to be used as a contact for support or sales. Copyright (2005) Hideki Electronics Inc. All Rights Reserved. The Honeywell Please call our customer service (refer to the Standard Warranty Trademark is used under license from Honeywell Intellectual Properties Inc.

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: