Pppoe - D-Link DIR-600 - Wireless N 150 Home Router User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.

PPPoE:

Select Dynamic (most common) or Static. Select Static if your
ISP assigned you the IP address, subnet mask, gateway, and
DNS server addresses.
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in
the next box.
Service Name:
Enter the ISP Service Name (optional).
IP Address:
Enter the IP address (Static PPPoE only).
DNS
Enter the Primary and Secondary DNS Server Addresses (Static
Addresses:
PPPoE only).
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time:
is maintained during inactivity. To disable this feature,
enable Auto-reconnect.
MTU:
Maximum Transmission Unit - You may need to change the
MTU for optimal performance with your specific ISP. 1492 is
the default MTU.
Connection
Select either Always-on, Manual, or Connect-on demand.
Mode Select:
D-Link DIR-600 User Manual
Internet Setup
PPPoE
21