Setting Up Your Router For Internet Access - NETGEAR DGN2000 - Wireless Router Setup Manual

Setting Up Your Router for Internet Access

When configuring your wireless router manually, you must log in to your wireless-N modem
router to set it up initially and to make any changes to your wireless router's settings later.
The factory default state is reset when you press the Wireless On/Off and WPS
buttons on the side panel of router simultaneously. See
Configuration and Password" on page 36
To access the router:
1. Type http://192.168.0.1 in the address field of your browser, and then click Enter.
You can also enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
.
Figure 11
A login window similar to the one shown in
Figure 12
Installing Your Router Manually (Advanced, Mac, and Linux Users)
"Restoring the Default
for more information.
Figure 12 will display.
17