Lap List Lap-List - FUTABA 3PK Instruction Manual

GOAL:
Set up a lap memory timer to track lap times
throughout a race, while using LV2 menus.
(If using LV3, select timer from Menu 1). (If
using LV1, first change level selection to
LV2. See p. 12.)
Where Next:
Levels LV2, LV3 Only
GOAL:
View laps previously run, then reset all laps,
while using LV2. (If using LV3, select LAP-LIST
from menu 1.) (If using LV1, first change
level selection to LV2, p. 12.)
Where Next:
STEPS:
Assign desired lapstart and restart switches.
Open and select menu 1.
Select TIMER.
Set type to lap memory timer.
Set total race time to 5 minutes.
Set pre-alarm time to warn you race end is
nearing at 15 seconds.
Set total timer/first lap timer to trigger
when throttle is pulled.
Test function on screen.
Close function and menu.
System timer: Reset radio's total timer after recharging to use as a method of tracking
on time between charges: from home screen, press and hold
View stored laps (LAP-LIST): See p. 31.
Adjust switch assignments (FUNC-SW): See pp. 34-35.
Place timer setup screen on quick menu for 2-keystroke access (DIRC-CALL): See p. 36.
DEFINITION: Displays all stored lap times, up to 100, and also stores total race
time, including run time after last but before reset/stop.
ADJUSTABILITY:
•
Reset single lap: Select lap,
•
Reset all laps in memory: Press
INTERACTION:
•
Requires switch assignment for lap counter in the FUNC-SW screen (see pp. 34-35).
•
Requires set up of timer as Lap Memory Timer (see p. 30).
•
Lap Navigation Timer does NOT store lap times (see p. 30).
DESIRED END RESULT: Store multiple lap times to analyze performance after the race.
STEPS:
Open and Select Menu 1.
Select LAP-LIST.
Scroll through laps shown on screen.
Reset all laps to prepare for next practice.
Close function and menu.
Change timer type to lap navigate timer (laps will not be stored) (TIMER): See p. 30.
Adjust timer settings (TIMER): See p. 30.
Change switch assignment to start/stop lap timer (FUNC-SW): See pp. 34-35.
31
INPUTS:
See FUNC-SW pp. 34-35.
to LAP MEMORY.
to ALRM.
to 15s.
Screen reads RDY.
Pull trigger. Timer starts counting.
Press selected switch (ex: PS-1) to store
first lap.
Note screen now displays the first lap's
time for 3 seconds, then displays current
running lap.
Press selected reset switch to stop timer.
Lap Listing LAP-LIST
cursor blinks next to it. Press
and together for 1 second.
INPUTS:
or as needed.
and together for 1 second.
to 5m.
for one second.
together.