Digital Proportional Adjustment - FUTABA 2PEKA Instruction Manual

For car's and boat's 2 channel digital proportional r/c system

Hide thumbs

Table Of Contents

Table of Contents

*When making these settings adjustments , do so with the motor disconnected

or the engine not running.

Servo Horn Installation Instructions.

Connect the receiver, servos, and other components and

then turn on the power switches to transmitter and re-

ceiver.

Be sure the Steering trim and Throttle trim on the transmitter

are at their neutral position .

At this time install the servo horn in the manner

described in the instruction manual provided

with the model this system will be used in.

Reversing The Servo Operation Direction

Should the servo operate in the opposite direction re-

quired for your application, reverse the rotation with the

reversing switch.

E.S.C. MC210CB / MC310CB

(Preparations)

Set the servo reversing switch on the transmitter to normal

side.

Turn the high point trim fully clockwise.

(Neutral Adjustment)

Have the throttle trigger at neutral.

Set the neutral trim to the point where the monitor lamp goes

off.

*The point where the monitor lamp changes from a rapid flashing

light to off is the neutral point.

(High Point Adjustment)

Hold the throttle trigger in the position just before full throttle.

Set the high point trim at the point where the monitor

lamp changes from a flashing light to steady light.

*The point where the monitor lamp

changes from a rapid flashing state to

a steady light is the high point.