Installing Cintiq21Ux On A Mount Arm - Wacom DTZ-2100D - 2005 User Manual

Installing Cintiq21UX on a Mount Arm

This product conforms to the Video Electronics Standard Association's (VESA) Flat
Panel Monitor Physical Mounting Interface Standard (FPMPMI).
This product can be removed from the stand and mounted on such apparatuses as
a VESA-standard mount arm. In order to do this, M4/0.7 mm screws, which are not
included with the product, are needed. Use screws that will, at the time of installation,
penetrate the surface of the product by no more than 15 mm. Use of longer screws may
result in damage to internal parts of the product.
Make sure that both your computer and the product are turned off and that all cables are
1
disconnected.
Place the display unit face down on a flat
2
surface. To prevent harm to the front of the
unit, first spread a cloth or other similar ma-
terial on the flat surface.
Remove the four screws that hold the stand
3
to the unit.
Using four M4/0.7mm screws, securely
4
mount the arm or similar apparatus to the
back of the unit.
Caution
When installing the unit on a mount arm or
other stand, always follow the directions in the
instruction booklet for the mount arm or stand,
as well as the instructions contained in this
document. Incorrect installation may result in the
product coming loose and falling and possibly
causing product failure.
Connect the cables and save the screws that you
5
removed in step 3.
8
Cin21UX_EN .indd 8 09.7.29 9:50:24 AM