Testing Controls And Input Tools; Testing The Expresskeys; Testing The Touch Strips - Wacom CINTIQ 21UX Installation Manual

TESTING CONTROLS AND INPUT TOOLS

If the Grip Pen, or the Cintiq ExpressKeys or Touch Strips do not work as you expect, it is a good idea to
first check the assigned functions or reset them to their default conditions. A quick way to reset a pen to
its default settings is to remove it from the T
been removed, place it back onto the display screen surface and the pen will be re-added to the T
list with its default settings.
Open the Wacom Tablet control panel and click on the A
click on the D ... button to open the D
IAGNOSE
displays dynamic information about the Cintiq pen display tablet and pen. This information is used
when testing Cintiq and your input tool.
If more than one Cintiq unit is connected to your system, be sure to select the unit for which you are
testing in the T I
ABLET NFO
Note: When testing your tool buttons, if a button is set to P
when the button is pressed. In this case you may want to change that button's function before testing.

TESTING THE EXPRESSKEYS

1. With the D
IAGNOSTICS
ExpressKeys. If you have more than one Cintiq unit connected to your system, be sure to select
the unit you are testing from the T
2. Test the keys by clicking them one at a time. Each time you press a key, its number will be
displayed next to either the L
are testing. (See Using ExpressKeys on page 28 for details on the button numbers reported.)
When you are done, click the C

TESTING THE TOUCH STRIPS

1. With the D
IAGNOSTICS
Strip. If you have more than one Cintiq unit connected to your system, be sure to select the unit you
are testing from the T
2. Slide your finger up or down along the entire length of the Touch Strip you want to test. As you
touch and move your finger along the Touch Strip, a number will indicate the current finger position
for the respective Touch Strip next to L
When you are done, click the C
list by clicking on the list's [ – ] button. After the pen has
OOL
IAGNOSTICS
column.
dialog box open, observe the T
I
ABLET NFO
K or R
EFT EYS IGHT
button to exit the dialog box.
LOSE
dialog box open, observe the T
I column.
ABLET NFO
T
EFT OUCH
button to exit the dialog box.
LOSE
button. In the dialog box that appears,
BOUT
dialog box. The D
- M or O
OP UP ENU PEN
I column as you test the
ABLET NFO
column.
K category, depending on which keys group you
EYS
I column as you test each Touch
ABLET NFO
S or R T
TRIP IGHT OUCH
dialog box
IAGNOSTICS
/R ..., that function will occur
UN
S .
TRIP
Troubleshooting
Page 43
OOL