Cisco AIR-AP1120B-A-K9 - Aironet 1100 Series Access Point Hardware Installation Manual page 32

Deploying the Access Points on the Wireless Network
Mount the access point at the indicated destination using the specified mounting method. For
b.
specific instructions, see these sections:
–
–
–
–
–
Optionally secure the access point using a padlock or security cable (refer to the
c.
Hasp Adapter" section on page 3-7
Connect the access point cables (Ethernet, optional power, optional antennas). For instructions see
d.
the
On power up, verify that the access point is operating normally by checking the LEDs. For additional
e.
information, refer to the
"Checking the Lightweight Access Point LEDs" section on page
For lightweight access points, after your access points are deployed, ensure that your controller is not
Step 4
configured as a master controller. A master controller should only be used for configuring access points
and not in a working network.
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
2-6
Horizontal or vertical surface, such as a ceiling or wall (refer to the
or Vertical Surface, page
Below a suspended ceiling (refer to the
page 3-4).
Above a suspended ceiling (refer to the
page 3-6).
On a cubicle wall (refer to the
On a desktop (see the "Using the Desktop Holster" section on page
"Connecting the Ethernet and Power Cables" section on page
"Checking the Autonomous Access Point LEDs" section on page 5-2
3-3).
"Mounting on a Suspended Ceiling" section on
"Mounting Above a Suspended Ceiling" section on
"Mounting on a Cubical Wall Partition" section on page
and the "Using the Cable Lock Feature" section on page
Chapter 2 Installing the Access Point
Mounting on a Horizontal
3-9).
"Using the Security
2-7.
6-3.
OL-4309-07
3-8).
3-11).
or the